Materials needed: Scissors, Rami, Ruler, Glue, Measuring and cutting:
You will need 2 pieces of hemp: anchor strand and strand knotting. Measure and cut a piece of hemp 5 times longer than your wrist around. This will be the anchor strand. For knotting strand, cut a piece of flax which was 2 feet long for every inch long bracelet to be desired. If you want 8 inch bracelet, cut a piece of hemp you will end up with excess hemp, but it's always better to end up with a bit of an edge than too little hemp.
Folding anchor chord in half to form 2 center folded end of the wrist strap will be the top, the ends will be the bottom. Cord knotting find the center, and put the anchor rope on it in the end of the anchor rope sticking out only about one inch above the knotting rope foldable, this little piece sticking out to form a circle to the cage bracelet.
With your anchor rope laid on the rope knotting at the center, you now will have the right and the left knotting strand knotting strand. Start with the left strand and put the anchor strands. Furthermore Place the right strand over the left strand down. Then take the right strand under the anchor pieces and through the loop on the left side made by the left strand.
Interesting strands to tighten the knot. Now take the right strand anchor strands to the left side. Noting the left strand over the right strand. Take the left strand under the anchor pieces and through the loop on the right side made by the right strand. Interesting knotting strands to tighten the knot. Now getting back to the original step and continue until you have made a bracelet with the length you want.
Once the desired bracelet and duration, taking all four strands and tie them together in a knot at the age of two years and cut the excess hemp. To add to the protection of the bracelet came apart, add a few drops of superglue to the end node. Now your hemp bracelet is complete and you can begin to learn more complex designs. Good luck and happy knotting!